Filter
Top Products
Problem solving guide
65
Water inlet fault
Problem Cause and remedy
The In-operation indica‐
t
or is flashing quickly.
The buzzer is sounding.
The Inlet/Drain indica‐
tor is flashing on and
off.
The stopcock is closed.
O
pen the stopcock fully.
The In-operation indica‐
t
or is flashing quickly.
The buzzer is sounding.
The Inlet/Drain indica‐
tor is flashing and fault
code or has ap‐
peared in the display.
Before rectifying the problem:
Switch the dishwasher off with the b
utton.
The water intake is restricted.
Op
en the stopcock fully and start the programme
again.
Clean
the water inlet filter (see "Maintenance").
The wat
er pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.