Filter
Top Products
Operation (Automatic and Manual modes)
25
Operating hours counters
The number of hours the appliance has
been in operation is stored in memory.
When the Grease filter symbol or the
Charcoal filter symbol lights up, the
operating hours counters are signalling
that the filters need to be cleaned or
changed. Further information about
cleaning and changing the filters and
resetting the operating hours counter
can be found under "Cleaning and
care".
Altering the operating hours counter
for the grease filters
You can set the operating hours
counter to suit the type of cooking you
do.
It is set at the factory for 30 hours.
– Select a shorter time of 20 hours if
you fry a lot.
– If you only cook occasionally we
recommend that you still select a
short time because grease which has
built up gradually over a long period
of time will harden on the filter and
make cleaning more difficult.
– Select a longer time of 40 or 50
hours if you use very little fat for
cooking.
Switch off the cooker hood. The
deflector plate must be retracted.
Remove the grease filters.
The controls are accessible via the slots
for the grease filters.
Press the run-on control 515 and
the operating hours control at
the same time.
The grease filter symbol and one of
the fan power level indicators will flash.
Fan power level indicators 1 to IS show
the time set:
1............................................... 20 hours
2............................................... 30 hours
3............................................... 40 hours
IS ............................................. 50 hours
Press the "" symbol for a shorter
operating time, or the "" symbol to
select a longer operating time.
Confirm the selection by pressing the
operating hours control .
All the indicator lamps will go out
If you do not confirm within 4 minutes,
the cooker hood will revert to the old
setting.