Filter
Top Products
Installation
51
Setting up for recirculation
mode
If site conditions are not suitable for the
cooker hood to be used with air
extraction, the appliance must be set
up for recirculation. A conversion kit,
available through your dealer of from
Miele is required for operating the
cooker hood in recirculation mode. You
will also need two charcoal filters (see
"Technical data").
Conversion kit DUU 150 with a plastic
grille is suitable for fitting in a non-
visible area at the top of the wall unit.
Conversion kit DUU 151 with a
stainless steel grille is recommended if
the grille is to be fitted in an area which
is visible.
Fit the conversion kit as described in
the installation instructions supplied
with the kit. Make sure that the slats
in the exhaust grille point towards the
centre of the room and not towards a
wall or the ceiling.
A non-return flap is not used in
recirculation mode.
Fit the charcoal filters (see "Cleaning
and care").
Electrical connection
Refer to the notes in “Electrical
connection” and “Warning and
Safety instructions” before
connecting to the electricity supply.
For appliances connected to an
external motor (EXT models):
Connect the cooker hood and the
external motor using the connection
cable and the six-pole plug
connector.
Connect the cooker hood to the
electricity supply.