Filter
Top Products
Operation
45
Starting a program
S
tart the program by closing the door
within four seconds of the last press
of a button.
The program will begin.
The Optical Interface comes on to show
that a pr
ogram has been started.
If you do not close the door within
four sec
onds, the indicator light of
the selected program will flash and
the message Press OK to Start will ap‐
pear in the display.
The program cannot be started until
you
press the
OK butt
on and close
the door within four seconds.
A program should only be canceled
in
the first few minutes, if at all. Oth‐
erwise important program stages
could be omitted.
Time display
The estimated duration of the program
select
ed appears in hours and minutes
in the display before the program be‐
gins. During the program, the time left
until the end of the program is dis‐
played.
Each program stage is indicated by a
symbol:
Pre-wash / Soak
Main wash
Interim rinse
Final rinse
Drying
Finish
The program duration displayed may
var
y with the same program. It is influ‐
enced by, among other things, the wa‐
ter temperature at each intake, the re‐
activation process, the type of deter‐
gent, the amount of dishware, and the
amount of soiling.
When a program is selected for the first
time, the display shows an aver
age
time for a cold water intake.
The times shown in the program over‐
view r
efer to standard test loads and
temperatures.
Each time a program is run, the elec‐
tr
onic module calculates the program
duration required according to the tem‐
perature of the water taken into the
dishwasher and the amount of dish‐
ware.