Filter
Top Products
Frequently Asked Questions
75
General problems
Problem Possible cause and solution
The Optical Interface is
flashing
quickly.
The warning buzzer is
sounding.
The indicator light of
the selected program
and the message Contin-
ue with OK will appear in
the display.
The dishwasher does
not start or the Flexi‐
Timer stops running.
The safe mode of the dishwasher was activated.
The following takes place:
– If you do not close the door within four seconds
of the last press of a button at program start
– If the door is open for longer than four seconds
during
a program or within the delay start time
P
ress the OK and close the door within four sec‐
onds.
The interior lighting
does not switch on
when the door is
opened.
The interior lighting has been switched off.
Switch the lighting back on again (see "Settings
menu - BrilliantLight").
Detergent residue is left
in the dispenser at the
end
of a program.
The dispenser was still damp when detergent was
added.
Mak
e sure the dispenser is dry before adding de‐
tergent.
The dispenser cover
cannot be closed.
Detergent residue is blocking the latch.
Remo
ve the detergent residue.
The inside of the door
and/or the int
erior walls
are wet after a program
has finished.
This is caused by the drying system and does not in‐
dic
ate a fault. The moisture will dissipate after a
while.