Filter
Top Products
Before using for the first time
21
Water hardness
The display changes to the water hard‐
ness setting.
– The dishwasher must be program‐
med for the wat
er hardness in your
area.
– Your local water supplier can tell you
the wat
er hardness level in your area.
– Where the water hardness fluctuates
e.g. between 10 - 16 gr/gal (10 - 15
°d),
always program the dishwasher
to the higher value (16 gr/gal or 15 °d
in this example).
It is useful to know your water hardness
so that you can
provide the service
technician with this information in the
event of any service calls.
Enter the water hardness below:
____________ gr/gal (°d)
The dishwasher is programmed at the
fact
ory for a water hardness level of 1
gr/gal (1 °d).
Selec
t the water hardness level for
your water supply and confirm with
OK.
See "Settings menu - Water hardness"
for more information.
The message Set up successfully complet-
ed will then
appear in the display.
After confirming this message OK, the
r
efill indicators Refill salt and Refill
rinse aid may appear.
Add salt and rinse aid if necessary
(see "Before using for the first time -
Dishwasher salt" and "Rinse aid").
Confirm the messages with OK.
The display will switch to the main
menu.
The prompt to set the dishwasher up
for first use will not appear agai
n after
you have run the first complete pro‐
gram.