Filter
Top Products
Frequently Asked Questions
74
Water intake fault
Problem Possible cause and solution
The buzzer sounds.
One of the following
fault messages appears
in the display:
Water intake fault
Open the water supply
The water supply is turned off.
T
urn on the water supply all the way.
Water intake
Before fixing the fault:
T
urn the dishwasher off using the sensor but‐
ton.
There is a problem with the water intake.
T
urn on the water supply fully and start the pro‐
gram again.
Clean
the water intake filter (see "Frequently asked
questions").
The wat
er pressure at the intake is lower than 4.35
psi.
Contact a plumber.
The following message
appears in the display
during the Energy Saver
pr
ogram:
Intake temp. too low
The intake water has not reached the required tem‐
pe
rature of 120°F (45°C) (see "Water connection -
Water intake").
Start the program again.
If the fault message appears again, select a differ‐
ent p
rogram.