Filter
Top Products
To run the descaling
programme
Maintenance
qrHI J L n
m
C
^
Touch the right arrow sensor until
“Maintenance“ is highlighted, and
confirm with OK, or,
^
If the machine is switched off, touch
the OK sensor whilst the machine is
switched off.
^
Select "Descale" and touch the OK
sensor.
^ Select "Start" and touch the OK
sensor.
The display will guide you through the
whole procedure. Please follow the
instructions to, for example, empty the
drip tray, fill the water container etc.
If the machine has already heated
up, it will cool down for approx.
10 minutes before starting to run
the descaling programme.
The descaling programme cannot
be cancelled once the OK sensor
has been touched. The programme
has to be completed through to the
end. This is a safety measure to
ensure that the machine is fully
descaled, and is important for the
long-term protection of the machine
and to ensure it functions correctly.
To dissolve the descaling tablets
^
take the water container out and fill it
to the k mark with lukewarm water.
(Do not use less water than this
because this would cause the
descaling programme to finish before
it has been completed properly).
^
Drop 2 descaling tablets in the
water. Allow the tablets to dissolve
fully before shutting the lid and
putting the water container back in
the machine.
During the descaling programme, water
containing descaling agent will run out
of the hot water and the central spouts.
This is followed by an activation period
before a little more descaling agent is
dispensed.
^ When a message asking you to fill
the water container with fresh
water appears, you should remove
the container and rinse it out
thoroughly with clean water. Make
sure all traces of descaling agent are
removed, and then fill it up to the k
mark with clean tap water.
Water will flow out of the spouts during
the rinsing process. Because the inside
of the machine is also cleaned during
this process you will be prompted to
Empty the drip tray at the end.
Descaling the machine
64