Filter
Top Products
. . . the machine door will not close.
^
Are the containers in position
correctly?
^
It might be necessary to adjust the
door hinges (see "Installation:
Adjusting the door hinges").
. . . you have selected a drink with
milk and "Heating phase" appears in
the display.
The energy-saving Eco mode is
activated. In this mode, the steam
system is heated up for preparing hot
milk or milk froth. After preparation the
steam system will cool down again.
Eco mode is the default setting but this
can be deactivated, if wished (see
"Settings - Setting Eco mode"). If Eco
mode is deactivated, the steam system
will remain heated and you can prepare
drinks made with milk without the need
for heating up beforehand. However,
with Eco mode deactivated, the coffee
machine will use considerably more
energy.
. . . coffee preparation has been
interrupted.
If the water container empties whilst a
drink is being prepared, a message will
appear in the display to ask if you wish
for the drink preparation to continue
after the water container has been
refilled. If you do not respond to this
question with "OK" within 5 minutes, the
drink will be cancelled.
^
Check the plumbing to the mains
water supply.
. . . only water is dispensed when
coffee has been selected.
The lid of the ground coffee chute has
been opened and closed, and then the
"Make the coffee?" (with ground coffee)
option has been selected. However, the
coffee chute has not been filled with
ground coffee.
After the drink has been dispensed, the
coffee machine will revert automatically
to making coffee with coffee beans.
The beans may have become jammed.
Pull the bean container out of the
machine and then push it back in
again.
...amessage keeps appearing
asking you to empty the drip tray
even though it is empty.
^ Have the contacts been properly
cleaned and dried?
^ Is the drip tray positioned correctly in
the machine?
^
Switch the machine off and then back
on again with the master switch.
^
Buff the contacts a little, e.g. with fine
glasspaper or emery cloth.
^
If this fault message continues to
appear, please call the Miele Service
Department.
. . . the machine does not rinse
through when switched on, even
though the Automatic rinsing
programme is set to "On".
If the temperature of the machine is
above 60 °C, rinsing cannot take place.
Problem solving guide
69