Filter
Top Products
]ö
Conversion to alternative types of gas
Replacing the small jet for the lowest
flame setting
Remove screw
d
from fitting
c
using an 8 mm wrench and a 12 mm
wrench to counterhold.
Then remove the screw fitting c
from b using a 12 mm wrench and a
second 12 mm wrench to counter-
hold.
Replace the restrictor
e
contained
in section
b with the correct restric-
tor from the table of jets (page 32).
Turn the air sleeve f to adjust the
two air vents
g
to the opening
illustrated (2 mm / 1/16").
Assemble removed parts in reverse
order and check for leaks by opera-
ting the wok burner without the cook-
top cover in place (ignite the flame
using a match).
Checking the first intake of air
b Fastening screw
c Air sleeve
Gap X must be 13 mm / 1/2" for both
natural and liquid gas.
If this is not the case, loosen the secur-
ing screw, re-position the air jet and
then tighten the securing screw.
Re-assemble the cooktop in the
reverse order.
]ö
Conversion to alternative types of gas
35