Filter
Top Products
]ö
Conversion to alternative types of gas
Important note:
When reassembling, it is important
to ensure that the profile
b
of the
control panel grips the appropriate
moulding
c on the lower housing.
Screw the three screws into the
burner base using a suitable philip-
eshead screwdriver.
Put the large burner cap base, the
burner ring, the large burner cap
and the wok/pan support in place.
Check that the tab of the large bur-
ner cap is correctly positioned in the
notch of the base and that the lug of
the base is correctly positioned in
the notch of the housing.
After conversion
After converting the gas cooktop to
an alternative type of gas, place the
label supplied with the jet kit on the
data plate over the type of gas being
used.
Check that there are no leaks.
Check that the burner is correctly
assembled.
Turn on the gas supply.
Turn on the electrical supply.
Light the burner:
When set at “low”, or when the control
knob is quickly turned from “high” to
“low” the flame should not go out.
When set at “high”, the inner cone of
the gas flame should be clearly
visible.
]ö
Conversion to alternative types of gas
36