Filter
Top Products
Bulletin Number Chapter 4: Operation 46 of 102
Existing Recipes
The operator can load a previously stored recipe from the Recipe Book. The Recipe book
also allows the operators to save the current running recipe. This can be done by performing
the following steps:
1. Touch the Recipe Book icon located on the Recipe Screen.
2. Select a stored recipe by changing the number next to “Recipe #”
3. Touch “Load” and then “Done” (This will take you back to the Recipe Screen.).
4. Touch “Accept New Recipe” to accept the loaded recipe into the blender.
To save a running recipe to the Recipe Book:
1. Go to the Recipe Book by touching the Recipe Book icon located on the Recipe
Page.
2. Select a stored recipe by changing the number next to “Recipe #”.
3. Touch “Save Running Recipe” and then “Done”
4-2 Operation Procedures
The objective of this section is to familiarize the reader with the Slide Gate blender recipe
menus, run mode operation, run mode menus and displays. Upon the completion of this
section, the reader will be familiar with the recipes and run mode displays that are available
on one blender, including the recipe book and recipe storage facilities. Other items covered in
this section are optional printer functions and report generation capabilities of the Slide
Gate/Auger blending system.
Topics covered in this section are:
• General Operation
• Recipe Menu
• Optional Printer Menu
All personnel operating the Slide Gate/Auger blending system should read this section of the
manual before operating the blending system.
Note: The blender monitors the operator’s entries and determines if the recipe
is valid before accepting the new recipe. If there is an error (such as the
recipe does not add up to 100% and the blender is in Percentage Mode.)
then a message is shown on the Recipe screen to alert the operator of the
problem. The “Accept New Recipe” button is only shown if the recipe is
valid and different from what is currently running on the blender.
Note: Recipes can also be changed while the blender is running. The new
accepted recipe is entered at the beginning of the next batch. This allows
the operator to modify the new recipe without affecting the blender until
they hit the “Accept New Recipe” button.
Note: Press “Push to Start or Stop” button to start blender.