Filter
Top Products
Gravimetric Batch Blenders w/Mitsubishi Control Chapter 3: Installation 45
• Clear Inventory
• Display Time & Date
Batch Interval or Timed Interval Printout
The Batch Interval item under the Recipe menu works in conjunction with the Auto Print
Interval to set the number of batches between printouts or on a timed interval between
printouts.
Time Printout
When entering the Report Setup menu, the operator will have to decide whether the printout
should be timed and by the number of batches between each printout. The operator will have
to toggle between the “Recipe Format” and the “Report Setup” screens to configure the
settings properly.
If you want to print out on a time format, press the button next to the “Auto Print/Clear
Interval” key. The screen will then prompt the operator to set the time interval in hours (1 to
24).
If you want to change the hours between printouts, press the “Auto Print/Clear Interval” key
again to change the value to the desired time.
The operator will then need to program in when they want to begin the timed printouts.
Simply select the time (0-23, {midnight =0} on a 24-hour clock) and press the “Done” key to
retain the current settings in the “Report Setup” screen.
Batch Printout
If you wish to print out the inventory information on a batch interval basis, then simply enter
in the desired batch interval under the Recipe Format screen and the printouts will occur each
time that the number of batches programmed is produced. To set the batch interval, press the
bottom button “Weigh Every Batch”, “Weigh Every Other Batch,” etc. to change this setting,
keep pressing this button until the desired option is reached. Once you have chosen the
number of batches that will be produced between printouts, press the “Done” key to return to
the Setup screen. If the “Auto Print Inventory” feature has been enabled in the “Report
Setup” screen, then the printer will produce printouts according to the settings instructed
above.
Print Inventory
The print inventory menu item is used to produce on demand, inventory printouts. Before
selecting this item, be sure that the printer is properly connected and ready. This function will
generate an inventory printout with the current date and time information.
Display Time and Date
The display Time and Date item in the upper right corner of the “Report Setup” menu is used
to verify the current time and date information.
Blender Calibration
Note: It is not necessary to calibrate the weight scale on a brand new blender,
although it is recommended that the calibration be checked periodically to