Filter
Top Products
Gravimetric Batch Blenders w/Mitsubishi Control Chapter 4: Operation 57
The blender monitors the operator’s entries and determines if the recipe entered is
valid before allowing the operator to accept the new recipe. If there is an error (such
as the recipe does not add up to 100% and the blender is in Percentage Mode) then a
message is shown on the Recipe screen to alert the operator of the problem. The
“Accept New Recipe” button is only shown if the recipe is valid and different from
what is currently running on the blender.
Recipes can also be changed while the blender is running. The new accepted recipe
is entered at the beginning of the next batch. This allows the operator to modify the
new recipe without affecting the blender until they hit the “Accept New Recipe”
button.
Existing Recipes
1. The operator can load a previously stored recipe from the Recipe Book. The Recipe
book also allows the operators to save the current running recipe. This can be done
by performing the following steps:
• Touch the Recipe Book icon located on the Recipe Screen.
• Select a stored recipe by changing the number next to “Recipe #”
• Touch “Load” and then “Done” (This will take you back to the Recipe
Screen.).
• Touch “Accept New Recipe” to accept the loaded recipe into the
blender.
To Save a running recipe to the Recipe Book:
• Go to the Recipe Book by touching the Recipe Book icon located on
the Recipe Page.
• Select a stored recipe by changing the number next to “Recipe #”.
• Touch “Save Running Recipe” and then “Done”.
2. Press “Push to Start or Stop” button to start blender.