Filter
Top Products
4
Mobile use
The Stellar Mobility bag allows the Stellar to be used in mobile situations, eg, in a
wheelchair. For setup and correct use, see the Stellar Mobility Bag User Guide. For
extended mobile use, the ResMed Power Station II external power supply unit can be used
as an additional power source. Limitations apply to the use of oxygen with the Stellar
Mobility Bag. For more information, contact your local ResMed representative.
Setting up for noninvasive use
WARNING
• The air filter cover protects the device in the event of accidental liquid spillage
onto the device. Ensure that the air filter and air filter cover are fitted at all times.
• Make sure that all the air inlets at the rear of the d
evice and under the device and
vents at the masks or at the leak port are unobstructed. If you put the device on
the floor, make sure the area is free from dust and clear of bedding, clothes or
other objects that could block the air inlets.
• Hoses or tubes must be non-conductive and antistatic.
• Do not leave long lengths of the air tubing or the cable for the finger pulse sensor
arou
nd the top of your bed. It could twist around your head or neck while you are
sleeping.
CAUTION
• Be careful not to place the device where it can be bumped or where someone is
likely to trip over the power cord.
• Make sure the area around the device is dry and clean.
Notes:
• ResMed recommends using the AC power cord supplied with the
unit. If a replacement
power cord is required, contact your ResMed Service Centre.
• Place the device on a flat surface near the head
of the bed.
1 Connect the power cord.
2 Plug the free end of the power cord into a power outlet.
3 Attach the H4i heated humidifier to the front of the Stellar.
If the H4i is not in use, and if applicable, conn
ect the antibacterial filter firmly onto the air
outlet of the device (see “Attaching an antibacterial filter” on page 9).
4 Connect one end of the air tubing firmly onto the air outlet of the H4i.
5 Connect the mask system to the free end of the air tubing.
6 Select the mask type (select Setup menu, then Clinical Settings, then Advanced Settings).
7 Perform Learn Circuit (see “Setup menu: Options” on page 16).
1
2
3
4
AC locking clip
AC power cord
5