Filter
Top Products
52
English
9.4 Cup releasing device cleaning
and adjustment
Importante
Before removing the cup realesing device, make
sure the cup bracket is in the brewing position -
that is the fork that holds the cup is positioned
under the brewing nozzles. If this is not the case,
stop and then restart the machine to allow the
automatic positioning of the cup bracket.
Remove the release ring locking screw.
Remove the device by unhooking the elastic
hook of the ring (fig. 60)
Check the satellite scrolls and, if need be, rinse
the device so as to remove dirt.
Important
Carefully blow all the inner parts with
compressed air before assembling the ring,
making sure that the cup bracket is in the
brewing position - that is the fork that holds the
cup is positioned under the brewing nozzles. If
this is not the case, stop and then restart the
machine to allow the automatic positioning of the
cup bracket.
Reassemble the release ring making sure that
the operating knob arrow is aligned with the
reference notch on the cup dispenser housing
(fig.61)
In case of disassembly of all the internal parts of
release ring assembly, refer to the specific
assembling instructions (fig.62)
fig.60
fig.61