Filter
Top Products
A P P E N D I X B
Resettingtheroomsystemto factorydefaults
66
To reset the room system from the BIOS
1. Connect a USB keyboard to the Lync appliance.
2. Turn onthe room system using thepower switch located on the bottom of the interactive flat
panel.
Small room Medium room Large room (×2)
N OT E
In large room installations, turn onboth interactive flat panels.
3. Press the DELETE key.
The Lync appliance enters BIOS mode.
4. Browse to the Advanced tab
5. Select Recovery Functionandthen press ENTER.
6. Set Image Recovery to Enabled.
7. Press ESC.
8. Browse to the Save & Exit tab.
9. Select Save Changes and Exit andthen select Yes.
The room system restarts, and thesoftware is reset to factory defaults.
10. Complete the procedurein Configuring your room system’s software on page 11.