Filter
Top Products
Instructions for the user
14
5. USE OF THE COOKTOP
WARNING
FIRE HAZARD
- Do not let the burner flame extend beyond the edge
of the pan.
- Turn off all controls when not cooking.
NOTE: Check that the flame cap crowns, the burner caps and grids are correctly assembled.
Before lighting the cooktop burners check that the flame diffuser rings are correctly in place with their
respective burner caps, making sure that the holes A in the flame diffusers are aligned with the plugs
and thermocouples. For the dual burner, place the burner caps G and F on the burner D, ensuring that
they fit snugly. The burner must then be placed on and fitted into the base B (taking care to use the pin C
as reference). The pan stand B supplied is for use with woks. The special pan stand H is for use with
woks.
5.1 Ignition with safety device
Each knob has a symbol that shows the corresponding burner (the example on the left shows the front
left burner).
The appliance is equipped with an electronic ignition.
- Just press and simultaneously turn the knob counter-clockwise to the minimum flame symbol until
the burner switches on.
- Keep the knob pressed down for about 2 seconds to keep the flame lit and to activate the safety
device.
- After switching the burner on it is recommended that the knob be left in the minimum position for
approximately 20 seconds before adjusting it to the required temperature.
It may happen that the flame goes out when the knob is released. In this case repeat the operation, but
keeping the knob pressed down for a longer period of time.