Filter
Top Products
17
Models 336, 338 & 339 Operating Procedures
Insert the prime plugs into the holes in the top of the
freezer door, and push down.
Figure 14
Step 4
Install the freezer door. Insert the baf fle rods through
the opening in the beaters and seat the door flush with
the freezing cylinder. With the door seated on the
freezer studs, install the handscrews. Tighten equally
in a crisscross pattern to insure the door is snug.
Note: The short handscrews go on the bottom
and the long handscrews go on top.
Figure 15
Step 5
Install the three d raw valves. Slide the two o--rings into
the grooves on the draw valves, and lubricate.
Figure 16
Lubricate the inside of the freezer door s pouts, top and
bottom, and insert the draw valves from the bottom
until the slot in the draw valves comes into view.
Figure 17
Step 6
Install the adjustable draw handles. Slide the o--ring
into the groove on the pivot pin, and lubricate.
Figure 18