24
Models 336, 338 & 339Operating Procedures
Step 4
Remove the o--rings from the air tubes and air orifices.
Step 5
Return to the freezer with a small amount of cleaning
solution. Brush clean the rear shell bearings at the
back of the freezing cylinders with the black bristle
brush.
Figure 38
Step 6
Remove the rear drip pan and take it to the sink for
cleaning.
Note: If the drip pan is filled with a n excessive amount
of mix, refer to the Troubleshooting Guide.
Step 7
Thoroughly brush clean all disassembled parts in the
cleaning solution making sure all lubricant and mix film
is removed. Take particular care to brush c lean the
draw valve cores in the freezer door . Place all the
cleaned parts on a clean, dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.