Filter
Top Products
40
Models 8752 & 8756 with Horizon® PumpTroubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
8. Excessive mix leakage
into the rear drip pan.
a. Worn or missing dr ive
shaft seal.
a. Install o r replace the seal. 18/ 42
b. Improper lubrication of the
drive shaft.
b. Lubricate properly. 18
c. Worn rear shell bearing. c . Contact a service
technician to replace the
rear shell bear ing.
-- -- --
d. The gear box is out of
alignment.
d. Contact a service
technician to align the
gear box.
-- -- --
9. The drive shaft is stuck in
the gear box coupling.
a. The gear box is out of
alignment.
a. Contact a service
technician to align the
gear box.
-- -- --
b. Rounded corners on hex
end of drive shaft or gear
coupling.
b. Replace damaged
component.
-- -- --
10. Freezing cylinder walls are
scored.
a. Broken pins on beater
assembly.
a. Repair or replace the
beater assembly. Be sure
the scraper blades are
properly seated on pins.
19
b. The beater assembly is
bent.
b. Repair or replace the
beater assembly. Contact
a service technician to
correct the cause of
insufficient mix i n freezing
cylinder.
-- -- --
c. Missing front bearing. c. Install the front bearing on
the back o f the freezer
door.
19
11. The Horizon® pump does
not operate.
a. The pump motor is not
activated.
a. Place the power switch in
the OFF position. Push
the reset button on the
pump drive motor. Return
the power switch to the
ON position. (On the
Model 8756, pr ess the
AUTO key for the opposite
freezing cylinder also.)
-- -- --