Filter
Top Products
X. INDEX
-18-
A
Automatic Condensate Evaporator 3
B
Battery Back-Up 6
C
Casters 2
Cleaning, The Condenser 5
Cleaning, The Exterior 6
Cleaning, The Interior 6
Clock, Setting The 24-Hour 11
Condensate Evaporator 3
Control Panel 7
Cord & Plug 3
Compressor Hold Down Provisions 3
Clearance 4
Customer Access Code 8
Customer Service Parameters 9
D
Date, Setting The 12
Daylight Savings Time, Setting 12
Defrost 4
Defrost Icon 13
Defrost Lockouts, Setting 14
E
Evaporator Coil Sensor 9, 15
F
Freight Damage 2
G
Gaskets, Replacing The 5
H
Hinge, Replacement 5
I
Internal Time Clock 6, 11
J
K
L
Legs 2
Light Switch 5
Location, Selecting Proper 2
Louver Assembly 5
M
Manual Defrost Cycle, Starting 13
Microprocessor Control, Features 6-7
N
O
Off-Cycle Defrost 13
ON/OFF Switch 4
P
Packaging 2
Parts Assembly 7
Parts, Spare & Replacement 17-18
Power Supply 4
R
Return Authorization 2
Room Temperature Offset 15
S
Self-Closing Door Feature 2
Sensor Temperatures, Viewing 15
Serial Tag 1
Shelf Pins 3-4, 6
Shelves 3-4, 6
Stay Open Door Feature 2
T
Temperature Scale, Changing The 10
Thermostat Set Point High 9
Thermostat Set Point Low 10
Tray Slides 4
Trouble Shooting 16
U
V
Vinyl, Protective Covering 2
W
Warranty 20
Warranty Regisration 6
Water Resistant Housing 7
Wiring Diagram 3
X
Y
Z
SPARE & REPLACEMENT PARTS LISTING NOTATIONS
1= This half half height door can be used as hinged right if mounted on top or hinged left on the bottom.
2= This half half height door can be used as hinged left if mounted on top or hinged right on the bottom.
3= Three section models use a combination of p/n 340-60074-02 in the left and right sections, and p/n 340-70-02 in the center section.
4= Part number applied to units built between August 2001 and March 2004 only.
5= Part numbers apply to units built after March 2004 only.
6= Plunger switch is mounted in hinge and used for automatic light operation.
7= Available for use with glass door models only.
8= If mounting hardware is also required, please specify model and mounting location at time of order to insure provision of correct standards.
9= These shelf kits are intended for mounting on pilasters and clips. If mounting hardware is also required, please specify model and mounting
location at time of order to insure provision of correct standards.
10= Mounting of these shelves is possible in the center section only of three section models.
11= Mounting of these shelves is possible in the left and/or right sections only of three section models.
IX. SPARE & REPLACEMENT PARTS LISTING - CONTINUED