Filter
Top Products
V. d - CLEANING THE EXTERIOR:
Exterior stainless steel should be cleaned with warm
water, mild soap and a soft cloth. Apply with a damp-
ened cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the sur-
face. Do NOT use cleansers containing chlorine, this
may promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit
with water, containing chlorinated cleansers, when
mopping the floor around the unit.
For stubborn odor spills, use baking soda and water
(mixed to a 1 TBSP baking soda to 1 pint water ratio).
V. e - CLEANING THE INTERIOR:
For cleaning anodized aluminum interiors, the use of
baking soda as described in section “V. d” is recom-
mended. Use on breaker strips as well as door gas-
kets. All interior fittings are removable without tools
to facilitate cleaning.
V. f - ADJUSTING THE SHELVES:
For shelves mounted on pins, first select the desired
location and remove the white plastic covers in the
interior back and sides by rotating them counter-clock-
wise. Remove the shelf pins by rotating them counter-
clockwise. Install the pins in the desired location by
rotating clockwise. Make sure the pin is securely tight-
ened down. Do not over tighten. Slide the shelf into
its new position, and replace the white plastic covers
into the holes vacated by the shelf pins.
VI. OTHER
VI. a - SERVICE INFORMATION:
Before calling for service, please check the following:
-6-
VII. MICROPROCESSOR CONTROL
VIII. a - MICROPROCESSOR CONTROL FEATURES:
Internal Time Clock
• Eliminates defrost time clock (refrigerator and freezer models only).
• Will display only at “Start Up”.
• Battery Back-up (eliminates the need to reset the control after a power failure).
• See “Setting The 24-Hour Clock” on Page 11. (Also required at “Start Up”)
• Will automatically update for Daylight Savings Time. See “Setting Daylight Savings
Time” on page 12.
V. CARE & MAINTENANCE (cont’d)
Your new Traulsen G-Series Refrigerator or Freezer is equipped with an elec-
tronic microprocessor control, which precisely regulates operation. It is sup-
plied from the factory completely ready for use. See pages 6 thru 15 for more
information.
VI. OTHER (cont’d)
VI. a - SERVICE INFORMATION (cont’d):
Is the electrical cord plugged in?
Is the fuse OK or circuit breaker on?
Is the power switch “ON”?
If after checking the above items and the unit is still
not operating properly, please contact an authorized
Traulsen service agent. A complete list of authorized
service agents was provided along with your Traulsen
unit. If you cannot locate this, you may also obtain
the name of a service agent from the Tech Service page
of our website: www.traulsen.com.
If service is not satisfactory, please contact our in-
house service department at:
Traulsen
4401 Blue Mound Road
Fort Worth, TX 76106
(800) 825-8220
Traulsen reserves the right to change specifications
or discontinue models without notice.
VI. b - SPARE PARTS:
Spare or replacement parts may be obtained through
a parts supplier or one of our authorized service
agents. A complete list of authorized service agents
accompanies this manual and is also posted on our
company’s official website @ www.traulsen.com.
VI. c - WARRANTY REGISTRATION:
For your convenience, the warranties on your new
Traulsen unit may be registered with us by one of two
methods. Completing the enclosed warranty card
(shipped with the unit), or by filling out the on-line
warranty registration form located on the Technical
Service page of our website (www.traulsen.com).
REFRIGERATOR
°F °C
FREEZER
SET