MODEL C24EA - DOOR
F35453 (July 2008) Page 10 of 68
Installation
1. Install latch assembly onto inner door panel with
spring pin toward bottom of door panel.
A. Apply Loctite 271 to threads of screws
before assembly and secure latch
assembly to inner door panel.
2. Install outer door housing assembly as outlined
under DOOR HANDLE.
3. Check opening and closing operation of door.
4. Check steamer for proper operation and leaks
around door seal.
HINGE BEARINGS
1. Close door.
2. Remove COOKING COMPARTMENT LEFT
SIDE PANEL as outlined under COVERS AND
PANELS.
3. Remove nuts from upper hinge located inside
front panel.
4. Open door slightly, and while holding door, pull
upper hinge away from front panel.
5. Pull upper hinge out of upper door hinge
bearing.
6. Lift door assembly up and off lower door hinge.
7. Pry hinge bearing out from door assembly.
8. Remove outer door housing.
Do not drive bearing into place. The inner
door panel could be damaged. Press bearing into
position.
NOTE: When replacing door hinge bearings, replace
both hinge bearings.
9. Position replacement hinge bearing over hinge
opening in door assembly.
A. Press hinge bearing fully into door
assembly using a C-clamp or equivalent.
10. Reassemble parts removed in reverse order.
11. Check door for fit and proper door gasket
sealing.
DOOR LATCH ADJUSTMENT
Opening a Jammed Door
Should the steamer door jam and cannot
be opened, do not force or pry the door as damage
will occur.
1. Lift up on bottom of door at the handle end to
disengage latch.
A. If door does not open, remove COOKING
COMPARTMENT RIGHT SIDE PANEL as
outlined under COVERS AND PANELS.