Filter
Top Products
- 11 -
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE DIRECT SPARK IGNITION CONTROL
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
1. Turn off the gas to the range and discon-
nect the power cord from the wall outlet.
2. Pull the range away from the wall so you
can access the back of the unit.
3. Remove the top rear cover (4 screws).
5. Remove the mounting screws.
6. Slide the two top pins out of the bracket
slots and remove the control from the
bracket.
4. Disconnect the wire connectors from the
direct spark ignition control.
Board Pin
In Slot
This section instructs you on how to service the direct spark ignition system components inside the
Gas Range.
COMPONENT ACCESS
SECTION 2SECTION 2
SECTION 2SECTION 2
SECTION 2
Screw (1 of 4)
Top Rear Cover