Filter
Top Products
- 23 -
SECTION 5SECTION 5
SECTION 5SECTION 5
SECTION 5
DIAGNOSTIC FLOW CHARTS
TECH TIPS
COOKTOP
Start
Done
Does cooktop
spark properly?
Is 120 VAC
present from J1-4
to J1-10?
Check the high voltage igniter wires for
continuity and proper connections from DSI
control to igniters. Make sure the burner
caps are the correct size and are properly
oriented. Also, if the supply voltage is
less than 102 VAC, the spark might not occur.
Diagnose the main wiring
harness. 120 VAC should
always be present at this point.
Replace the DSI control.
With the cooktop
knob in LITE, is
120 VAC present
from J1-4 to J1-9?
Diagnose the cooktop wiring
harness. Check the cooktop
switches for the proper function.
NOTE: The range must be plugged in for
at least 40 seconds before this test can begin.
yes
no
no
no
yes
yes