Filter
Top Products
- 5 -
b)Install the conversion cap on the gas
distribution valve with the L.P. side fac-
ing up (you will see L.P. stamped inside
the cap, as shown).
L.P. Gas
The range is manufactured to use natural gas.
To convert the range to use L.P. gas, the fol-
lowing steps are performed:
1. Turn off the gas and electrical supplies to
the range.
2. Remove the storage drawer from the
range.
3. Locate the gas distribution valve at the
rear of the range. To convert the gas
distribution valve:
a)Unscrew the conversion cap from the
gas distribution valve. Note the differ-
ence between the L.P. and natural gas
ends of the cap.
L.P. GAS CONVERSION
4. To convert the bake burner:
a)Open the oven door and remove the
oven racks.
b)Use a 1/2" open-end wrench and turn
the orifice hood down snug onto the pin
(approximately 2-1/2 turns). DO NOT
OVERTIGHTEN THE ORIFICE. The
burner flame cannot be properly ad-
justed if this conversion is not made.
Pin
Natural Gas:
Unit is manufactured
for natural gas
L.P. Gas:
Turn down 2-1/2 turns in
this direction
Orifice Hood
Natural Gas
L.P. Gas