Filter
Top Products
Using Your Microwave Oven
Contmued
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows “88:88”. If the electric
power ever goes off, the Display will again show
“88:88” when the power comes back on.
You can cook without setting the clock, but the
Display will be blank after cooking.
To set the clock, touch CLOCK SET. The
Display will show “0” and the colon will flash.
NOTE: The first number Pad must be touched
within 5 seconds or the Display will go blank. If
the Display goes blank, touch CLOCK SET
again and continue.
Touch Number Pads for the correct time of
day. The Display will show what numbers you
touched in the order you touched them. This
example shows 25 minutes after 3 o’clock.
Touch START. The colon will stop flashing.
The clock is set.
If you have touched in an incorrect time,
such as 12:65, “Err” will show on the Display.
Touch CLOCK SET and start over.
NOTE: To m the clock, touch CLOCK SET.
The current time will show on the Display and the
colon will disappear. Continue to set the clock as
shown above.
Using CANCEL
Touch CANCEL to:
l
Erase instructions if you make a mistake during
programming.
l
Cancel the Minute Timer.
l
Stop the oven temporarily during cooking.
NOTE: The oven may also be stopped during a
cycle by opening the door. Close the door and
touch START to continue cooking.
12