Filter
Top Products
6. Touch START.
The AUTO SET Indicator Light will stay
on while the oven is cooking in the pre-
programmed cycle. If you selected a
Cook Power other than high, the Cook
Power Signal Light will also come on.
This shows you the oven is cooking at a
selected Cook Power.
The Display counts down the time to
show how much cooking time is left.
For 2 of every 10 seconds, the Display
will show the Cook Power you se-
lected, if you are using a Cook Power
other than high.
When Auto Set ends, “End” will
show on the Display and 4 beeps
will sound. (You can stop the
beeping by opening the door or
by touching CANCEL.) “End” will
remain on the Display and a
beep will sound every 30 seconds
(to remind you that food is left
in the oven] until the door is
opened or CANCEL is touched.
The Display will then show the
time of day.
NOTE: You can set COOK to follow Auto Set, if desired. Touch in instructions for “Cooking at
High Power” (page 7) or “Cooking at Lower Cook Powers” (page 8).
Changing the pre-programmed setting
You can change the pre-programmed cooking time and Cook Power in AUTO SET to the time and
power you most often use. To change the AUTO SET setting, follow these steps.
1. Place food in the oven and close the door.
2. Touch AUTO SET twice.
3. Touch the Number Pads for the new desired cooking time. If high Cook Power is desired,
skip to Step 6.
4. Touch COOK POWER.
5. Touch the Number Pad for the desired Cook Power.
6. Touch START. The oven will cook at the new cooking time and Cook Power you selected. After the
cooking is complete, the oven will remember that time and Cook Power for future use. NOTE: If the
electric power ever goes off, the oven will go back to the pre-programmed 2 minutes, 30
seconds’at high Cook Power setting.