Filter
Top Products
Programming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the
instruction is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command Pad, you will not
hear a tone. The instruction is not correct.
If you want to remove the If you want to replace the
programming tone: programming tone:
l
Open the door.
l
Open the door.
l
Touch CANCEL twice, then
l
Touch CANCEL twice. then
touch START.
touch START.
l
The tone will not sound for
l
The tone will sound for any
any touch. correct touch.
Setting the clock
If you want to remove all
tones, except the minute
tlmer signal:
l
Open the door.
l
Touch CANCEL twice, touch
0, then touch START.
l
All audible tones will be
cancelled.
l
To replace the tones,
repeat the above steps
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the
electric power ever goes off, the display will again show all 8’s when the power comes
back on.
You can cook or use the Minute Timer without setting the clock, but the display will be
blank after cooking.
DO THIS...
THIS HAPPENS...
I. Touch CLOCK SET.
2. Touch Number Pads for the
correct time of day.
3.
Touch START.
The Display will show a “0” and
the colon will start to flash. The
first Number Pad must be touched
within 5 seconds or the Display will
go blank. Touch CLOCK SET again
and continue.
The Display will show what numbers
you touched in the order you
touched them. This example shows
3:25.
The colon will stop flashing.The Clock
is set.
If you have touched in an incorrect
time, such as1265 “Err” will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To %t the clock, touch CLOCK SET. The current time will show on the Display
and the colon will flash. Continue to set the clock as shown above.