Filter
Top Products
gramming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the
instruction is not correct, or because the tones have been removed.
EXAMPLE:
If you touch a Number Pad before you touch a Command Pad, you will not
hear a tone. The instruction is not correct.
If you want to remove the
If you want to replace the
If you want to remove all
programmlng tone:
programmlng tone:
tones, except the mlnute
l
Open the door.
l
Open the door.
timer slgnal:
l
Touch CANCEL
twice,
then
l
Touch CANCEL lwlce, then
l
Open the door.
touch START.
touch START.
l
Touch CANCEL
twice,
touch
l
The tone will not sound for
l
The tone will sound for any
0, then touch START.
any
touch.
correct
touch.
l
All audible tones will be
cancelled.
l To replace the tones,
Setting the clock
repeat the above steps.
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the
electric power ever goes off, the display will again show all 8’s when the power comes
back on.
You can cook or use the Minute Timer without setting the’clock, but the display will be
blank after cooking, however AUTO START will not work unless the clock is set.
DO THIS...
.
m
1. Touch CLOCK SET.
2. Touch Number Pads for the
correct time of day.
3.
Touch START.
THIS HAPPENS...
The Display will show a “0” and
the colon will start to flash.The
first Number Pad must be touched
wlthln 5 seconds or the Display will
go blank.
Touch CLOCK SET again
and continue.
The Display will show what numbers
you touched
in the order you
touched them.
This example shows
3:25.
The colon will stop flashing. The Clock
is set.
If you have touched in an incorrect
time, such as12:65, “Err” will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To mtthe clock, touch CLOCK SET. The current time will show on the Dlspiay
and the colon will flash. Set the clock as shown above.