Filter
Top Products
1
The electronic oven control
Timer set
Electronic and off
display
pads Clock pad
Oven Temperature Electronic Hour Minute Start/ Off/
seettor pads MEALTIMER pads pads enter cancel
control pads
pad pad
Display/clock
l
When you first plug in the range, every-
thing on the display will light up for l-2
seconds, then a time of day and “PF’ will
appear on the temperature display. If,
after you set the clock (page 12) “PF
again appears on the display, your elect-
ricity was off for a while. Reset the clock.
l
When you are not using the oven,
the
control is an accurate clock.
l
When you are using the oven or Minute
Timer,
the display will show times, temp-
erature settings, and what command pads
have been pressed.
l
When showing the time of day,
the
display will show the hour and minutes.
l
When you are using the Minute Timer,
the display will show minutes and sec-
onds in the following sequence:
- For settings from l-59 minutes,
the
display will count down each second.
- For settings 1 hour or over,
the
display will count down each minute.
l
When you are using Cook Time and/or
Stop Time,
the display will show hours
and minutes.
Command pads
The command pads tell the oven what to
do and in what order. A few examples:
-Clock
tells the oven you are going to set
the clock.
-Off/Cancel
tells the oven to turn off.
Each command pad (except Off/Cancel and
Start/Enter) has its own Indicator Light. The
Indicator Light comes on when you push the
command pad.
Using the control lock
The control lock prevents unwanted use of
the oven by disabling the control panel
command pads.
NOTES:
l
Control lock is only available
when oven
is not in use or control has not been set.
l
Set
control lock when cleaning the control
panel to prevent oven from accidentally
turning on.
To lock or deactivate the control panel:
Push and hold the Start/Enter pad for 5 sec-
onds. A single tone will sound and “Lot”
and fi will appear on the temperature
display.
When the control is locked, “START?” will
appear on the display and three tones will
sound if you push any command pad.
To unlock the control panel:
Push and hold the Start/Enter pad for 5 sec-
onds. A single tone will sound and “Lot”
and fi will disappear from the temperature
display.
11