Filter
Top Products
1.
Be sure surface unit controls are OFF.
\ Opening
Receptacle
/
2. Line up opening in the reflector bowl and
notch in trim ring with the surface unit
receptacle.
Terminal
3. Hold the surface unit as level as possible
with the terminal lust started into the
receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle.
5. When the terminal is pushed into the re-
ceptacle as far as it will go, the surface unit
will fit into the trim ring.
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a trim ring gets discolored, some of the
utensils used may not be flat enough. Or
some may be too large for the surface unit.
In either case, some of the heat that is meant
to go into or around a utensil goes down
and heats the trim ring. This extra heat can
discolor it.
31