Filter
Top Products
PROBLEM
--I
Self-Cleaning
cycle will not
operate
Cooking
results are not
what you
expected
POSSIBLE CAUSE
You have not set the Oven
Selector and Oven Temperature
Control Knob to CLEAN.
SOLUTION
Set both the Oven Selector and Oven
Temperature Control to CLEAN.
The range clock does not show
the correct time of day.
The Lock Lever is not in the
CLEAN position-all the way to the
right.
The Start Time Dial does not show
the correct time of day or the knob
is not all the way out.
The Stop Time Dial is not set
ahead to the time you want the
cleaning cycle to stop.
The range is not level. Level range. (See Installation Instructions.)
The oven temperature seems too
low or too high.
Adjust the oven temperature control. (See
“Adjusting the oven temperature control”
on page 12.)
Preheat oven if called for in recipe.
Use only tested recipes from a reliable
source.
Refer to a reliable cookbook for recom-
mended pan type and size.
Allow 1% to 2 inches (4-5 cm) on all sides
of the pans for air circulation. There must
be a minimum space of 1 inch (2.5 cm).
1
Use cooking utensils with smooth, flat
used.
bottoms that fit the surface units being
Reset clock to show the correct time of
day. (See page 11.)
Move Lock Lever all the way to the right.
Reset the Start Time Knob to show the
correct time of day. Pull knob out all the
way.
See Step 3 in “Setting the controls” on
page 19 for proper setting instructions.
You have not preheated the oven
as the recipe calls for.
The recipe has never been tested
or is not from a reliable source.
The pans are not the type or size
recommended in the recipe.
There is not proper air circulation
around pan when baking.
The cooking utensils are not the
proper shape or do not fit the
surface units being used.
26