Filter
Top Products
TROUBLE
5-1
EJU00595
TROUBLESHOOTING
If any trouble happens on your water vehicle, use this section to check for the possible
case.
If you can not find the cause, or if the procedure for replacement or repair is not
described on this owner’s manual, ask your Yamaha Water Vehicle dealer or qualified
mechanic for the proper service.
The trouble shooting chart contains “TROUBLE”, “POSSIBLE CAUSE”, “REMEDY”,
“REFER PAGE”.
Check the possible cause and remedy, and also the referred page for the maintenance
steps, to solve the trouble.
E
The engine does not
start
Starter motor does not turn over
8Multifunction
meter
8Stop switch
8Fuse
8Battery
8
Starter
component
Starter motor turns over
8Fuel cock
8Fuel
8Fuel tank
8Spark Plug
8Spark Plug cap
8Crankcase
8Fuel filter
8Choke
“LOCK” mode is selected
Lock plate is not in place
Burned out
Run down
Poor terminal connections
Terminal is eroded
Faulty
“OFF” position
Empty
Stale or contaminated
Water or dust collected
Built-up pressure
Fouled or defective
Not fitted or loose
Filled with water
Clogged or water collected
Knob automatically return
8Select “START” mode
Install lock plate
8Replace the fuse and
Check wiring
8Recharge
8Tighten as required
8Clean
8Have a service at
Yamaha dealer
8Turn the fuel cock to
“ON”
8Refill as soon as
possible*1
8Have service at
Yamaha dealer
8Have service at
Yamaha dealer
8Open the fuel tank filler
cap and release pressure
8Clean or Replace
8Fit properly
8Crank engine with plug
out until clean
8Have service at
Yamaha dealer
8Tighten the choke cable
tension adjust nut
2-15
2-7
4-23
4-20
4-21
—
—
2-6
3-1
4-10
4-10
2-6
4-15
4-15
5-7
4-11
4-19
POSSIBLE CAUSE REMEDY Refer Page
*1 : Turn the fuel cock to “RES (reserve)” to return to shore.
EJU00596a
TROUBLESHOOTING CHART