Filter
Top Products
E
3-25
EJU00508a
POST-OPERATION CHECKS
1) After removing the vehicle from the
water, put the vehicle in the horizon-
tal position.
2) Flush cooling system to prevent the
cooling system from clogging up with
salt, sand, or dirt. “Refer to pages 4-1
for the cooling system flushing proce-
dure”.
3) Lubricate the internal components by
performing “LUBRICATION” at page
4-3, if storing the water vehicle for
more than a week.
4) Drain residual water from the exhaust
system by alternately pulling and
releasing the throttle lever for a peri-
od of 10 to 15 seconds while the
engine is running.
cC
Do not attempt to run the engine at full
throttle or for more than 15 seconds
while the vehicle is out of the water. The
engine may overheat and/or seize.
5) After operating the vehicle from the
water, wash down the hull, handle-
bars and drive unit with fresh water.
GP7-070