Filter
Top Products
E
3-8
EJU00915a
Switches
First, place the vehicle in the water to pro-
vide adequate engine cooling. Push the
starter switch 1 and start the engine,
then push the engine stop switch 2.
Restart the engine and pull the engine
stop switch lanyard on your left wrist to
remove the lock plate 3 from the engine
stop lanyard switch. Verify that the engine
stops immediately, when the engine stop
switch pushed or the lock plate remove
from the engine stop lanyard switch. Be
sure the lanyard is in good condition with
no frayed or broken parts. A damaged
lanyard must be replaced; it should never
be repaired or tied together.
q
e
w
GP7-074
EJU00453a
Cooling water pilot outlet
Check that water comes out from the out-
let(s) while engine is running in the water.
Refer to page 2-9 for correct operation of
the device.
EJU00454
Multifunction meter
Check the operation of multifunction
meter. Refer to page 2-13 “MULTIFUNC-
TION METER” for correct meter opera-
tion.
GU0-023
A/ SET
B
C
MODE
WARNING
mph
2
1
0
3
4
5
6
7
8
1000
r/min
GP7-075