Filter
Top Products
4. Pull the lamp cover forward and remove it from the projector. Put the lamp cover in a safe
place.
T TIP
If the cover is difficult to remove, insert a flat screwdriver or small coin into the slot on the
bottom of the lamp cover to gently pry the cover open.
5. Use a Phillips screwdriver to loosen the two captive screws from the bottom of the lamp
module.
N NOTE
Don’t try to remove these screws. Captive screws can’t be removed, but they must be loose.
6. Use the handle on the bottom of the lamp module to slide out the lamp and remove it from the
projector.
C HA PTER 5
Maintainingyour interactive whiteboardsystem
39