Filter
Top Products
Submenu setting Description
Projector Mode Adjusts the projection mode to Front, Ceiling, Rear or Rear Ceiling.
I IMPOR TAN T
SMART recommends that you never change this setting from the
Ceiling projection mode.
Source Adjusts the input source to VGA-1, VGA-2, Composite, S-Video or
HDMI.
USB Control settings
This menu allows you to associate a video source with a USB receptacle on the ECP.
Submenu setting Description
USB1 Source Enables touch for the selected video source (VGA-1, VGA-2, HDMI
or Disabled) by associating the video source with the room computer
USB receptacle (USB1) on the ECP.
USB2 Source Enables touch for the selected video source (VGA-1, VGA-2, HDMI
or Disabled) by associating the video source with the laptop USB
receptacle (USB2) on the ECP.
T TIP
These settings are only available for SMARTUX60 projectors running DLP firmware version
1.0.0.4 or later.
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting Description
DHCP Determines if the projector’s IPaddress and other network settings
are dynamically assigned by aDHCPserver or manually set.
l
On allows the network’s DHCP server to assign adynamic IP
address to the projector.
l
Off allows you to manually set the projector’s IP address and
other network settings.
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.
A PPEND IX A
Remotelymanagingyour systemthrough anetworkinterface
63