Filter
Top Products
These commands inform you of the current system settings. These commands are available even
when the projector is in Standby mode.
Command Response
get lamphrs lamphrs=[current lamp hours of operation]
get syshrs syshrs=[current projector hours of operation]
get fwverddp fwverddp=[current projector firmware version]
get fwvernet fwvernet=[current network firmware version]
get fwvermpu fwvermpu=[current processor firmware version]
get fwverecp fwverecp=[current ECP firmware version]
get vgaoutnetenable vgaoutnetenable=[current]
get signaldetected signaldetected=[true or false]
get usb1source usb1source=[Video source associated with the USB 1connector on
the ECP]
get usb2source usb2source=[Video source associated with the USB 2connector on
the ECP]
T TIP
The get usb1source and get usb2source commands are only applicable to SMARTUX60
projectors running DLP firmware version 1.0.0.4 or later.
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 70 for setting absolute
and adjustment commands.
Command Command target range Response
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
78