Filter
Top Products
These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command Command target range Response
set restoredefaults [none] restoredefaults=done
set lamphrs [target] =0 lamphrs=0
set vgaoutnetenable [target] =on
=off
vgaoutnetenable=[target]
set usb1source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
set usb2source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
T TIP
The set usb1source and set usb2source commands are only applicable to SMARTUX60
projectors running DLP firmware version 1.0.0.4 or later.
N NOTE
The Network and VGAOut setting’s features are off by default. Select on to activate these
features.
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
80