5
Important Safeguards (Continued)
The "Tape Threading Label", shown in
Figure 1-10, is attached to the left side of both upper
and lower taping heads. This label provides a
convenient tape threading diagram. More detailed
tape loading and threading information is provided in
this manual in the set-up procedure section.
The "Warning-Sharp Knife" label warns operators
and service personnel of the extremely sharp knife
used to cut the tape at the end of the box sealing
operation. The label, shown in Figure 1-9, is
located on the orange knife guard between the
applying roller assembly and the buffing roller
assembly. Never operate taping heads with knife
guard removed.
The following two labels are located on the upper
and lower taping heads. Replacement part
numbers for these two labels are listed in Section II.
Figure 1-10 – Tape Threading Label
Figure 1-9 – Knife Warning Label
Before working with the taping heads or loading/
threading tape, refer to Figures 3-1 and 3-2, in
Section II, to identify the knife location. Keep hands
out of these areas except as necessary to
service the taping heads or to load/thread tape.
The "Up/Down/Lock" and "Out/In" labels, shown in
Figure 1-8, are attached next to the crank handles
that raise and lower the upper assembly (taping
head) and move the belts in and out to match box
width.
Figure 1-8 – Operating Labels