12
Installation and Set-Up (Continued)
CAUTION – Machine weighs
approximately 159 kg [350 pounds]
uncrated.
16. Continue with the remainder of the Installation
and Set-Up procedure through page 14.
12. Check for free action of both upper and lower
taping heads.
WARNING – Keep hands/fingers
away from tape cut-off knife under
orange knife guard. Knife is extremely
sharp and can cause severe injury.
Push buffing roller into head to check for free,
smooth action of taping heads.
13. Install machine stops (from parts box) as
shown in Figure 2-1D. Use the lowest hole
position and bolt into the lowest threaded insert
on the column. (The upper hole position in the
stops are only used when the taping heads are
adjusted to apply 50 mm [2 inch] tape legs.)
14. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 2-2A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
15. Use appropriate material handling equipment
to remove the machine from the pallet and
move it into position.
Whenever the machine is lifted with a fork
truck, insure that the forks span completely
across the machine frame and do not contact
any wiring or mechanism under the machine
frame. In some cases the lower taping head
may need to be removed to avoid damage.
Figure 2-1 – 800a3 Frame Set-Up