Filter
Top Products
11
Installation and Set-Up
After the machine has been uncrated, examine the
case sealer for damage that might have occurred
during transit. If damage is evident, file a damage
claim immediately with the transportation company
and also your 3M Representative.
Machine Set-Up
The following instructions are presented in the order
recommended for setting up and installing the case
sealer. Following them step by step will result in an
installation in your production line that best utilizes
the many features built into the case sealer. Refer
to Figure 3-1 to identify the various components of
the machine.
Note – A tool kit consisting of metric open
end and hex socket wrenches is provided
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
Important – Read "Warnings" on page 16
before attempting to set-up the case
sealer for operation.
Receiving And Handling
5. Cut cable ties that secure upper assembly to
machine bed on each side of machine.
6. Install height adjustment crank handle on top of
left column as shown in Figure 2-1A.
7. Crank upper assembly up high enough to allow
clear access to lower taping head. Remove
and discard the two cushion shipping blocks.
8. Spread side drive belts to full open position with
crank on side of machine frame.
9. Remove tape drum bracket bolts (4) from top
crossbar and install tape drum bracket from
parts box on top crossbar as shown in
Figure 2-1B.
10. Cut and remove cable ties on both upper and
lower taping heads. (Applying/buffing rollers
are held retracted for shipment.)
WARNING – Follow this step
carefully as spring pressure is
applied to applying and buffing arms when
cable tie is removed. Keep hands/fingers
AWAY from tape cut-off knife under
orange knife guard. Knife is extremely
sharp and can cause severe injury.
Hold taping head BUFFING ROLLER and cut
and remove cable tie that holds applying/
buffing arms retracted. See Figure 2-1C.
Allow buffing/applying arms to extend slowly.
11. Cut and remove tie straps that hold lower
taping head in place.
1. Lift fiberboard cover off pallet after removing
staples at bottom.
2. Remove protective wrapping around machine.
3. Remove hardware that secures case sealer legs
to pallet.
4. Cut and remove cable tie that secures black
electrical conduit to the electrical mast on top of
machine.
PACKAGING AND SEPARATE PARTS