Filter
Top Products
16
Operation (Continued)
1. Turn electrical supply off and disconnect before servicing taping heads or performing any
adjustments or maintenance on the machine.
2. Turn electrical supply off when machine is not in use.
3. Before turning drive belts on, be sure no tools or other objects are on the machine bed.
4. Keep hands and loose clothing away from moving belts.
5. Never attempt to work on any part of the machine, load tape or remove jammed boxes from
the machine while machine is running.
6. When feeding boxes to the machine by hand, push box in from end only – DO NOT PUSH
WITH HANDS ON ANY CORNER OF THE BOX.
7. Taping heads utilize an extremely sharp cut-off knife. The knife is located under the orange
knife guard that has the 'WARNING – SHARP KNIFE" label. Before loading tape, refer to
Section II, page 6, Figures 3-1 and 3-2 to identify the knife location. Keep hands out of these
areas except as necessary to service the taping heads.
8. Failure to comply with these warnings could result in severe personal injury and/or equipment
damage.
WARNINGS
Electrical "On/Off" Switch
The box drive belts are turned on and off ("Off"
button is red) with the electrical switch on the side of
the machine frame.
Tape Loading/Threading
See Section II, Pages 7 and 8
Note – The case sealer has a circuit breaker
located in the electrical enclosure on the lower
left side of the machine frame. If circuit
becomes overloaded and circuit breaker trips,
see "Maintenance – Circuit Breaker", page 21.
Note – If lower tape drum is mounted in
alternate lower outboard position, remove
taping head from machine bed by pulling
straight up, insert threading needle in taping
head and replace taping head. Install tape
roll on drum (adhesive on tape leg up), thread
tape under knurled roller on outboard mount,
then attach tape to threading needle and pull
tape through taping head with threading
needle.
CAUTION – Taping head weighs
approximately 7.2 kg [16 pounds]
without tape. Use proper body mechanics
when removing or installing taping head.
Emergency Stop Switch
The machine electrical supply can be turned off by
pressing the latching emergency stop switch. To
restart machine, rotate emergency stop switch
(releases switch latch) and then restart machine by
pressing green (On) button on side of machine
frame.