17
Operation (Continued)
Figure 3-2 – Controls, Valves and Switches
1 Electrical "On/Off" Switch
The box drive belts are turned on and off (off
button is red) with the electrical switch on the
side of the machine guard at the infeed end.
Note – The air valve has provisions for lockout/tagout
according to plant regulations.
2 Main Air "On/Off" Valve/Pressure
Regulator/Filter – Figure 3-3
This set of pneumatic components controls,
regulates and filters plant air supply to the two
separate control circuits of the case sealer.
Pressure Regulator regulates main air pressure to the
machine to adjust pressure, pull knob up and turn –
push down to lock setting.
Filter removes dirt and moisture from plant air before it
enters the case sealer pneumatic circuits. If water
collects in bottom of bowl, lift up on the valve on the
bottom of bowl to drain.
"On/Off" Valve – "On" turn to "SUP" – "Off" turn to
"EXH".
Note – Turning air supply "Off" automatically bleeds
air pressure from the case sealer air circuits.
Note – The case sealer has a circuit breaker located
in the electrical enclosure on the lower right side of
the machine frame. If circuit becomes overloaded
and circuit breaker trips, unplug the machine electri-
cal cord and determine cause of overload. After two
minutes, remove the electrical control box cover and
reset the circuit breaker by pressing the "Reset"
button and then the "Start" button on the circuit
breaker. Replace the control box cover, plug ma-
chine electrical cord into outlet and restart machine
by pressing green "On" button.
WARNING
• To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and qualified
personnel to operate and/or service this
equipment
− Turn electrical and air supply off and
disconnect before performing any
adjustments, maintenance or servicing the
machine or taping heads
WARNING
• To reduce the risk associated with mechanical
and electrical hazards:
− Turn electrical and air supply off and
disconnect before performing any adjustments,
maintenance or servicing the machine or
taping heads