Filter
Top Products
30
Figure 5-1 – Gate Cams
Gate Operation
Figure 5-1
A – Permanent gate cam
B – Removable gate cam
C – Kicker cam
The 800af is shipped with both gate cams A and B
installed. With both cams the entire range of box
lengths can be run (150-760 mm [6-30 inches]).
However if only boxes longer than 305 mm [12
inches] will be run, cam B can be removed to
increase the production rate. Refer to the box rate
chart in specification section.
Drive Belt Tension
Belt tension must be adequate to positively move
boxes through the machine and belts should run
fully on the surface of the pulleys at each end of the
frame. The idler pulleys on the infeed end are
positioned by tension adjustment screws. To
adjust tension, see "Maintenance – Drive Belt
Replacement/Tension Adjustment".
Taping Head Adjustments – Refer to Section II
TAPE WEB ALIGNMENT – Section II
TAPE DRUM FRICTION BRAKE – Section II
APPLYING MECHANISM SPRING – Section II
ONE-WAY TENSION ROLLER – Section II
• To reduce the risk associated with mechanical and electrical hazards:
– Turn electrical and air supply off and disconnect before performing any adjustments, maintenance or servicing
the machine or taping heads
WARNING