3M 800af-s Food Saver User Manual


 
24
Operation (Continued)
Note - Box drive motors are designed to run at a moderate temperature of 40° C [104° F]. In some cases they
may feel hot to the touch. Adjustment of the machine or taping heads are described in the "Adjustment"
section of this manual.
IMPORTANT – If drive belts are allowed to slip on
box, excessive belt wear will occur.
Figure 3-13 – Box Size Set-Up
Box Sealing
1. Connect electrical and air supplies.
2. Turn main air valve "On" and adjust air regulator if pressure does not read 5 bar gauge pressure [70 PSIG].
3. Press electrical "On" button to start drive belts.
4. Continually feed boxes to case sealer, case sealer will automatically space entrance of boxes to machine.
5. Turn electrical and air supplies "Off" when machine is not in use.
6. Reload and thread tape as necessary.
7. Be sure machine is cleaned and lubricated according to recommendations in "Maintenance" section of this
manual.
Figure 3-13
If the box is hard to move under the top head or is
crushed, raise the top head slightly.
If the box movement is jerky or stops under the top
head, move the side drive belts in slightly to add
more pressure between the box and drive belts.
Note: Upper head has unique feature for
overstuffed boxes. The head will raise up to
13 mm [1/2 inch] to compensate for this type of
condition.
To reduce the risk associated with pinch, entanglement, and impact hazards:
Never attempt to work on any part of the machine, load tape, or remove jammed boxes from the machine
while the machine is running
Keep hands, hair, loose clothing, and jewelry away from moving belts and taping heads
WARNING