3M 800af-s Food Saver User Manual


 
29
Maintenance (Continued)
Circuit Breaker
The case sealer is equipped with a circuit breaker
which trips if the motors are overloaded. Located
inside the electrical control box on the side of the
machine, the circuit breaker has been pre-set at
2.2 Amps and requires no further maintenance.
Air Line Filter – Figure 4-5
Periodically check the air line filter to drain water and
clean as necessary. Do not allow water to go above
the filter element.
Figure 4-5 – Air Line Filter
If circuit is overloaded and circuit breaker trips,
unplug machine from electrical power:
1. Determine cause of overload and correct.
2. Remove electrical enclosure cover.
3. Press the red "Reset" button and then the
green "Start" button.
4. Replace cover.
5. Plug in machine. Wait two minutes.
6. Press machine "On" button, on the side
guard, to resume case sealing.
Knife Replacement, Taping Head
See Section II, "Maintenance – Blade (Knife)
Replacement".
To reduce the risk associated with mechanical and electrical hazards:
– Turn electrical and air supply off and disconnect before performing any adjustments, maintenance or servicing
the machine or taping heads
WARNING
To reduce the risk associated with
mechanical and electrical hazards:
Allow only properly trained and qualified
personnel to operate and/or service this
equipment
WARNING