32
Adjustments (Continued)
Gate Pressure Regulator
Figure 5-3
The gate air pressure is controlled by a regulator
mounted under the machine frame. This provides
adjustment of the gate lifting force. When light weight
boxes are being run the gate pressure can be
reduced to minimize lifting of the box.
Gate Stroke Setting
Figure 5-4
The machine is initially set at the maximum gate lift
of 25 mm [1 inch]. However this can be reduced if
needed for special situations. To do this, remove
the center roller section and turn the stop nuts
clockwise until the desired lift is achieved.
Figure 5-3 – Gate Pressure Regulator
Figure 5-4 – Gate Stroke Setting
• To reduce the risk associated with
mechanical and electrical hazards:
– Turn electrical and air supply off and
disconnect before performing any
adjustments, maintenance or servicing the
machine or taping heads
WARNING